Xiao Bian's own headset is the snake factory's Beihai Giant Demon (without the version of wheat), bought less than 2 years, the first beam cover and earphone sleeve are rotten. Of course, after all, the snake factory is not known for its durability and longevity. Searched on the Internet, there are examples of heads and tails... There are people who spit on snake skins...
This is this: http://item.jd.com/835758.html
Of course, as a small series of digital products, because of the inherent demolition of things and hobbies, naturally feel that this is not a big deal, you can buy their own accessories just fine. Of course slightly, there is no genuine accessories, a treasure to just buy some accessories.
Because the middle of the headset will be in the middle of the line, the head girder needs to be disassembled and replaced. Well, open!
The rubber plug is dug out and you can see the screw. 4 left and right, a total of 8.
However, there are no eggs used to open the fixed buckle on both sides, although the headphone beam loose, but can not take it ... ... I thought for a moment, simply cut off, anyway, the old is useless.
After the cut, see the internal sponge liner, but this time you will realize that you need to open the single-sided headphones.
Break the side of the four screw holes, you can under the side earmuffs. However, there is no use for the same egg, and the headphone hinge should still be used to hold the headphone frame when it is still used... It is impossible to use the brute force and the cards.
If you push the top of the hinge, you will find that the headphone cord is completely fixed through the hinge. Even if the middle shaft is pushed out, the headphone cord is still connected to the bottom ear cap. There is no solution...
Dying and struggling, unscrew the two screws, hoping to extend the arm inside the method of separation of the wire, but I think too much. After unscrewing, the front and rear plastic extension arms are still fully buckled and cannot be removed.
Â
In the end, wit is like me, and in fact it is impossible. Wanted a trick to go with the sword.
Cut the new head girdle along the inner test and wrap it around the head girder. With double-sided tape on the back and sewn on the thread... er er... probably maybe maybe there is salvation...
Â
Oh yeah, there's the final big move after the final big move...
to sum up:
To be honest, the devil's design in the North Sea is really... completely detachable. In the absence of violent destruction, the internal line of the headset is very tight and almost impossible to open. Well, it may be that Xiaobian’s hands-on ability is not enough... But really, most headset replacement headsets need to face the problem of routing... Now the design of the headset is basically a design that does not give room for disassembly. Therefore, if hands-on party members with hands-on capabilities similar to Xiao Bian want to change their hands? forget it……
Â
Â