[For all boxes] Lynx box remote control failure, button no response how to do

1. Check if the battery of the remote control is not powered. Press the power button. If the power of the remote control is off, the power supply is insufficient (if there is a small amount of power, the light will be on but the button operation is invalid). The battery can be removed and reloaded. Try it out or replace it with a button battery.


Lynx Box Communication Group:, try to re-code if the battery is normal, try the remote control to re-code,
Lynx box code method: Unplug the power of Lynx box; press the "volume +" and "volume -" keys on the remote control at the same time, do not let go and keep this state, while plugging the power of Lynx box After the cat's box is powered on, you can release the remote control by seeing the kitty moon fishing splash screen on the TV screen or the kitten twisting (preferably to this interface and releasing) Press the key; the red LED of the remote control flashes and the code begins to match. If the code is successful, the red light will only go off after a few flashes.
Pairing is completed, if not, it may be that during the distribution process, the buttons are released, and no pairing is done. Then, retry the steps above.

Precautions:
Put the battery in. Note that the positive “+” is facing upwards. After installing the battery, close the battery cover and tighten it clockwise.
Test whether the remote control is powered on: On the left side of the remote control, near the power button, there is an LED indicator. Press the red POWER button. If the lamp is lit red, the remote control itself is powered and the battery is not installed. The indicator lights of the other keys of the TMB-100A will light, and the indicators of the other keys of the TMB-100E and TMB-100C will not light up; the model of the box can be viewed on the back of the box.
(However, the 100C model is a code that needs to be plugged in with power, that is, without plugging in the power supply)
Lynx Box 1S code method: with the box (50 cm), long press the OK button + return button light, will flash three times, after the three flashes indicate that the code is successful.